How to install the stainless steel gate? What precautions should be taken when installing stainless steel gates? Below I will summarize it for you.



    1. First, measure the thickness of the main and reverse rails and the thickness of the gate. The sum of the three dimensions should be smaller than the reserved size of the gate. If it is smaller, you can prepare for installation. If it is larger, try to find the cause.
    2. Look at the direction of the water flow and whether the gate is a front water stop (panel water stop) or a rear water stop.
    3. Measure and find the center line of the lifting point and the position and size of the water stop at the bottom of the gate, and clarify the position of the bottom water stop of the gate in the sluice.
    4. According to the position of the water stop at the bottom of the Datian hydraulic gate in the sluice, put the bottom sill at the bottom of the sluice, try to make the bottom water stop at the center of the bottom sill panel, and measure the flatness of the bottom sill surface with a level ruler. Start spot welding firmly.
    5. According to the width of the water outlet and the thickness of the gate, determine the position of the main rail, use a vertical line to hoist the main rail surface, and then spot-weld the steel bars and embedded bars of the main rail to stabilize the connection.
    6. According to the size of the water outlet and the width of the gate, the reverse rail is placed, and the method is the same as the method of stabilizing the main rail.
    7. Install the lintel, according to the height of the water outlet as the bottom of the lintel, the surface of the lintel is flush with the track surface of the upstream surface, and then connected with the embedded steel bar by spot welding.
    8. After they are all connected by spot welding, re-measure the width and height of the water outlet and the width of the door slot. If they all meet the dimensions required by the drawing, start welding to be stable; if they do not match, adjust the welding to be stable.
    9. After the welding is stable, you can try to install the gate along the gate, lift the gate smoothly, and prepare for pouring concrete according to the size reserved in the second phase;
Through the above introduction, you should know how to install the stainless steel gate!